2-POWER 2P-KN.2GB0B.033 - 2 GB - 1 x 2 GB - DDR3 - 1333 MHz

2 GB DDR3 at 1333 MHz — that's the sweet spot for reviving an older desktop without overthinking it. The 2-POWER 2P-KN.2GB0B.033 is a single 240-pin DIMM, built to the most common JEDEC profile, so it just works in virtually any motherboard that takes unbuffered DDR3.

Why this module?

• Non-ECC, unbuffered design — no server-grade quirks, just drop-in compatibility for consumer boards.
• Single-rank (1Rx8) layout keeps signal integrity clean, especially when you're populating all slots.
• Standard 1.5 V operation — no need for exotic cooling or extra power headroom.
• CL9 latency matches the typical DDR3-1333 spec, so the BIOS will pick it up automatically.

Who is it for?

If you're running an older Core 2, Phenom, or early Core i-series system that's struggling with 1–2 GB of RAM, this stick is a low-cost way to get back to comfortable multitasking. It's also a sensible replacement for a dead module in a working machine — you don't need to pay extra for heat spreaders or overclocking features you'll never use.

Key specifications

• Capacity: 2 GB (1 x 2 GB)
• Type: DDR3
• Speed: 1333 MHz (PC3-10600)
• Form factor: 240-pin DIMM
• Error correction: Non-ECC
• Buffering: Unbuffered
• Voltage: 1.5 V
• CAS latency: CL9
• Rank: Single rank (1Rx8)
• Application: Desktop PC
• JEDEC standard: Yes
• Heat spreader: No

How to use

Turn off the PC, open the case, and press the module into a free DDR3 slot until the clips click. That's it. The system will recognise it at POST, and you're done. If you're adding it to an existing stick, matching the speed and voltage (1333 MHz, 1.5 V) is ideal, but the module will also run at lower speeds if the motherboard downclocks it.

Tip: Before buying, check your motherboard's maximum supported RAM and the number of slots. This 2 GB stick is perfect for a dual-channel setup when paired with an identical module.