ROBITRONIC Aluminium Servo Double Arm 23T (90°) Red

This durable aluminium servo double arm with a 23T spline and a 90-degree angle optimizes mounting on the servo main shaft with small screws on the side. It features a thickness of 2mm, 3mm holes, and a hole spacing of 20mm and 24mm.

The red aluminium double servo arm has 23T splines and a 90° angle. Small screws on the sides optimise mounting on the servo main shaft.

The CNC-machined aluminium double servo arm is fastened to the servo with one mounting screw from above and two side hex socket screws. The side screws clamp the arm onto the output shaft. The backlash-free connection allows more direct linkage and relieves the gearbox; even if a screw is lost, the arm stays attached.

• Specifications
• Distance between Holes: 20 mm and 24 mm
• Thickness: 2 mm
• Hole Diameter: 3 mm

The 90° angle between the two sides is designed for cross-linkage of throttle and brake, as found on some 1/10 and 1/8 off-road vehicles.

Suitable for servos with 23 teeth on the gear ring or output shaft, e.g. from KoPropo, Sanwa, JR, Airtronic, Graupner, Multiplex and Spektrum.

• Technical Data
• Total length servo arm: 35 mm (in both directions)
• Arm thickness: 3 mm
• Total height: 7 mm
• Press-in depth for servo gear: 3 mm
• Angle between both sides: 90°
• Mounting holes: M3 (2 pcs.)
• Hole spacing mounting holes to center: 20 mm (hole 1) / 24 mm (hole 2)

In the box

• 1× Anodized double arm servo lever 23 teeth
• 2× Hexagon socket screws
• Brand: Robitronic