Weidmüller A2C 16 PE spaiļu bloks, A sērija, PUSH IN, 16 mm², zaļš/dzeltens

8 kV impulse withstand and a working range from -60 °C to +130 °C — that's what the Weidmüller A2C 16 PE brings to your DIN rail. This protective earth terminal is built for panel builders and electricians who need a ground connection that doesn't quit, even in the harshest industrial environments.

Key specs that matter

• PUSH IN connection: 2 points, solid conductor up to 25 mm² direct insert, no ferrule needed
• Rated cross-section: 16 mm², wire range AWG 20–4
• Mounting: DIN rail TS 35, standard for any cabinet
• Colour: green/yellow — unmistakable PE coding
• Insulation: Wemid (PA 66), UL 94 V-0 flammability rating
• Pollution degree 3 — rated for tough, dirty conditions

Why you'll like it

The PUSH IN system cuts wiring time by up to 50% compared to screw terminals — just push the solid wire in, done. No screwdriver, no torque worries. The dual connections let you loop conductors easily, so you can ground multiple circuits from one terminal without extra jumpers. Vibration? Not a problem — the connection stays tight and maintenance-free.

Where it fits

• Control cabinets and switchgear — PE bonding
• Motor control centres — grounding connections
• Building services distribution panels
• Anywhere with vibration or temperature swings

How to use

Snap the terminal onto a TS 35 DIN rail. Strip the wire to the recommended length (check the Weidmüller datasheet for exact values), insert solid or ferruled flexible wire into the PUSH IN opening until it clicks. To release, press the orange lever. For looping, use the second connection point — no extra parts needed.

Pro tip: For flexible wires without ferrules, use the PUSH IN with a ferrule — it's designed for that. And always verify the green/yellow colour coding before commissioning — it's your safety net.